Nail the door frame to the studs.
Finish nails for hanging doors.
The first few times you install casing we suggest drawing light lines called reveal lines 3 16 in.
Is a 15 or 16 gauge finish nailer big enough for hanging.
Cut off the protruding door shims with a fine tooth saw or a utility.
Nail the trim to the jamb and studs.
Drive 4d finishing nails into the jamb and 6d finishing nails into the wall.
From the edge of the jamb to align the casing to the door jamb and windows photo 1.
Nail the trim to the jamb and studs.
Use 3d or 4d nails every 12 inches along the bottom and 6d or 8d nails along the top of the moulding piece.
If the wall is plumb and the casing rests flush against it tack 8d finish nails through it at the other two hinge locations.
Cut and install trim on the second side of the door.
Drive two finish nails into each set of shims to hold the jamb in place.
Usually three or four sets of door shims evenly spaced along the jamb are plenty.
Trim any exposed shims by scoring them with a knife and then breaking along the line.
Cut and install the trim on the second side of the door.
Drive 6 finishing nails through the trim and into the studs behind the wall spacing the nails about 16 inches apart.
In this article we ll focus on installing standard prehung doors.
Tack an 8d finish nail through the face of the hinge side casing 3 inches below the miter into the trimmer.
Start with the casing around the doors and windows.
Finish nails or finishing nails are generally made of 15 or 16 gauge steel wire making them slightly thicker in diameter than brad nails.
The added thickness means that finishing nails create a stronger hold than brads.
The door will stay in the opening and you can move the hinge jamb side to side to fix any mistakes in the frame.
Nail the trim to the door frame with no.
Trim any exposed shims by scoring them with a knife and then breaking along the line.
Nail the trim to the framing with no.
Shim and nail the latch side jamb shim behind the latch side jamb to make an even gap between the door and the jamb.
I nail the shims to the jacks with drywall nails.
Nail the head moulding piece to the door jamb with trim nails.
Drive 6 finishing nails through the trim and into the studs behind the wall spacing the nails about 16 inches apart.
These have a door jamb that s 4 9 16 in.
Most articles talk about using 8 d finish nails but the largest finish nail gun seems to be 15 gauge quite a bit smaller than 8 d and i believe that framing nailers use clipped or full round heads not conducive to setting.
To prevent splitting during this step avoid nailing 1 4 inch from the side edges and an inch from the edge of the moulding.
Put the door in the opening and nail near the top hinge with a 2 1 2 finish gun nail.
This makes them useful for heftier applications with thicker material such as cabinets or baseboards.
Wide and are made to fit into a 2x4 wall that s 4 1 2 in.
